5V 500mA Switching Circuit

Caution: I won’t take any responsibility for any damage!

Circuit Overview

This is a circuit that I found on 5V/2A switching with Wemos D1 mini without relay, which is able to switch 5V at 500mA (or more) with a microcontroller like the D1 mini or an ESP8266.

It should be able to handle more than 500mA, but I only tested it with nearly 500mA.

Required Parts

Required parts:

• 1x 1kΩ Resistor
• 2x 10kΩ Resistor
• 1x BC548C Transistor
• 1x IRF9510 MOSFET
• Some wires

Optional parts:

• A micro-USB port
• A microcontroller like a NodeMCU V2 (ESP8266)
• A 3W 15Ω Resistor
• A 3W high power LED

This is the circuit setup:

Here is the Fritzing file for this circuit:

circuit.fzz

In this Fritzing circuit, a NodeMCU was used, which can be found here: esp8266-fritzing-parts

The micro-USB port was used to provide the 5V/500mA. It also powers the NodeMCU. As a load, a high power 3W (red) LED was used. Of course, other loads can also be used. If a high power LED is used, it is important to use a resistor for the LED that can handle the required power. In this case: 3W

If the circuit needs to be compact, instead of the BC548C, an IRLML2505, and instead of the IRF9510, an IRLML6402 can be used. Both parts are available as SMD.